[ Pobierz całość w formacie PDF ]
.SPECIFIC VEHICLE ALARM FITTING INSTRUCTIONS REV.00www.cobra.itxMAKEKIAMOD.PICANTOYEAR04 → PETROLDIESELALARM/SIRENPosition the compact alarms and the sirens in the engine compartment, on the support of the POSITIONshock absorber, driver’s side.Pass the cables using the original fairlead located on the left of the servobrake.POWER SUPPLY+30: connect to the big wire located at the entrance of the fuse box, underthe driver’s side dashboard.-31: connect with a cable terminal to one of the ground terminals behind the left lateral bulkhead, driver’s side.IGNITION WIRE+15/54: connect to the YELLOW wire, in the 22 way black connector, located on the left of the fuse box, under the driver’s side dashboard.DIRECTION INDICATORSConnect to the wires: GREY and WHITE/ORANGE in the wiring harness coming out of the 21way black connector, located behind the left lateral bulkhead, driver’s side.ELECTRIC WINDOWSPositive control signalFront window, driver’s side:cut the 2 mm2 RED wire in the wiring harness coming out of the relevant control push-button.Front window, passenger’s side: cut the 2 mm2 BLUE/RED wire in the wiring harness coming out of the connector of the driver’s side door.CENTRAL DOORS LOCKING Motor control signal As the door is not furnished with the actuator, it is necessary to install a two wires additional motor.IMMOBILISATION POINTFuel pumpCut the BROWN/ORANGE wire in the wiring harness coming out of the 16 way grey connector, located behind the left lateral bulkhead, driver’s side.STARTER+50: Cut the 1,5 mm2 WHITE wire in the wiring harness located along the steering column, under the driver’s side dashboard; as alternative: directly in the connector of the ignition key.BONNET SWITCHInstall an additional switch on the headlights support plate, near the left lateral headlight.DRIVER’S SIDEConnect to the GREEN/BLACK in the wiring harness coming out of the 18 way white DOOR SWITCHconnector, behind the left lateral bulkhead, driver’s side.FRONT RIGHT AND REARConnect to the ORANGE/GREEN wire, in the wiring harness coming out of the 16 way grey DOORS SWITCHconnector, behind the left lateral bulkhead, driver’s side.BOOT SWITCHConnect to the ORANGE/GREEN wire in the wiring harness coming out of the 18 way white connector, behind the left lateral bulkhead, driver’s side.Note: This information is not binding, therefore it must be considered only an example for installation purposes that must be executed kipic04gbb.docas per the instructions given on the product installation manual
[ Pobierz całość w formacie PDF ]