[ Pobierz całość w formacie PDF ]
.SPECIFIC VEHICLE ALARM FITTING INSTRUCTIONS REV.00www.cobra.itXMAKERENAULTMOD.CLIOYEAR97 → PETROLDIESELALARM/SIRENPosition the compact alarms and the sirens on the left side of the engine POSITIONcompartment near the shock absorber.Pass the cables through the original rubber core hitch.POWER SUPPLY+ 30: connect to the wire corresponding to the B2 position of the R1connector located under the covering of the dashboard.- 31: connect with a ring terminal to the car body.IGNITION WIRE+ 15/54: connect to the wire corresponding to the B6 position of the R1connector under the covering of the dashboard.DIRECTION INDICATORSConnect to the wires corresponding to the D7 and C7 positions of the R1 connector located under the covering of the dashboard.CENTRAL DOORS LOCKING Negative control signal Connect to the wires corresponding to the position nr.1 (lock) and nr.5(unlock) of the connector of the interior central door locking switch.CENTRAL UNIT POSITIONPosition the modular systems under the dashboard, passengers side, fastening them to the lateral panel.IMMOBILISATION POINTFuel pumpCut the 1,5 mm2 YELLOW wire located in the wiring harness placed in the fuse box inside the engine compartment, driver’s side.STARTER+50: Cut the 2 mm2 WHITE wire located in the 28 ways brown connector in the position marked A1.Otherwise, it’s possible to cut the 3mm2ORANGE wire located in the 2 ways gray connector under the dashboard.BONNET SWITCHInstall an additional switch on the covering of the windshield wiper.DOORS SWITCHConnect to the wire corresponding to the A2 position in the R8connector located under the covering of the dashboard.BOOT SWITCHConnect to the 1 mm2 WHITE wire connected to the boots interior lamp.Note: This information is not binding, therefore it must be considered only an example for installation purposes that must be executed recli97gbb.docas per the instructions given on the product installation manual
[ Pobierz całość w formacie PDF ]